Table of Contents
Advertisement
Running or Installing HOSTKEY
Rebooting VANGARD Mail
Exiting from HOSTKEY
Returning the Voice Mail COM2 to the default setting:
Chapter 6: Options
You can now choose whether to run the HOSTKEY program on your laptop computer from the
HOSTKEY diskette or to install HOSTKEY permanently on your laptop hard disk.
Note: If you run the HOSTKEY program on your laptop, you will need to repeat this procedure
every time you use HOSTKEY.
To run the HOSTKEY program on your laptop computer:
1.
Turn on the laptop computer, and insert the HOSTKEY disketteinto the laptop floppy drive.
At DOS:\->: Type A:\HOSTKEY and press Enter.
2.
3.
Check that the BUSY light on the Voice Mail is not lit. Remove the plug from the 18VDC
jack, and then replug it into this jack to start the Voice Mail.
You will see the Main Menu on your laptop computer display.
Or to install HOSTKEY permanently on your laptop hard disk:
At C:\->:
1.
Type MD to make a directory, and name the directory HOSTKEY.
2.
At C:\->:
Type COPY A: C:\HOSTKEY to copy the HOSTKEY file (HOSTKEY.exe) onto the direc-
tory.
3.
At C:\HOSTKEY->:
Type CDHOSTKEY to change to the directory you just created.
At C:\HOSTKEY->:
4.
Type HOSTKEY to run the program from that directory.
To reboot the Voice Mail, if necessary, using HOSTKEY:
Press CTRL-ALT-F10.
To exit from HOSTKEY:
Press CTRL-X.
To return the Voice Mail's COM2 to the default setting:
1.
Log into the System Admin Mailbox.
2.
Enter the security code, if required.
Enter SA to access the System Administrator Options.
3.
4.
Enter C2 for Modem/COM2.
The system responds with the Ready prompt. Ready confirms that the selected COM has
been reset to the default setting.
(C2 is a service option. It is not be listed in the SA help menu.)
5.
Hang up.
Using HOSTKEY
VANGARD Mail/i-Series Quick Setup Guide
69
Advertisement
Table of Contents
