Panasonic KX-TD816 Installation Manual page 321

405
45
0
CO Line Programming
CPC Signal Detection Incoming Set
Description
Assigns the expected minimum duration of the CPC Signal on
incoming CO calls. If this is programmed, the system disconnects
the line when the CPC Signal is detected.
Selection
l
CO line number:
KX-TD816;
01 through OS, * ( *
=a11 CO lines)
KX-TD1232;
01 through 24, * ( *
=a11 CO lines)
l
Time (milliseconds):
Disable
(no detection) /
100 / 200 / 300 /
400 / 500 / 600
Default All CO lines - 400 ms
Programming 1.
2.
3.
Conditions
4.
5.
6.
Keep pressing
SELECT
until the desired time is displayed.
Press
STORE.
To program another CO line, press
NEXT
or
PREV,
or
SELECT
and the desired CO
line number.
7.
Repeat steps 4 through 6.
8. Press
END.
Enter 405.
Display
:
CPC Detection
Press
NEXT.
Display: CO Line NO?->
Enter a CO line
number.
To enter CO line number 01, you can also press NEXT.
Display example: C001:4G3msec
9
In the case of
KX-TD1232, COO1 through CO 12 are for the
Master
System and CO13 through CO24 are for the Slave, if available.
l
To assign all CO lines to one selection, press the * key at step 3. In
this case, the display shows the contents programmed for Cool.
l
You
may disable CPC Signal Detection for a CO line.
. Program [415] "CPC Signal Detection Outgoing Set" is used to
program CPC Signal Detection for outgoing CO calls.
Feature References Section 3, Features,
Calling Party Control (CPC) Signal Detection
*Direct Inward System Access (DISA)
4-84
System Programming
*: Available for KX-TD 1232 only.