Using Reset Button - Panasonic KX-TD816 Installation Manual

61
l
Troubleshooting
/
PROBLEM PROBABLE CAUSE
POSSIBLE SOLUTION
During a power interruption,
l
A DPT or APT is
l
Disconnect the DPT or APT and
extensions connected to jack connected to the jack. connect a single line telephone.
numbers 1,2,9, 10 for KX-
l
The dialing mode (tone or
l
Set the Tone / Pulse switch to the
TD816, and 1, 2,9, 10, 17,
pulse) is improper. other position.
18 for KX-TD1232 do not
operate.
l
During system connection Interface between the Connect the interface between the
operation for KX TD1232, systems is disconnected. systems and press the Reset Button
originating an intercom/ on both systems.
CO call from a system to
the other system is not
nossible.
Originating a CO call, Call The corresponding CO Program the CO button. See
Transfer, or Conference
button does not exist on the Section 4.2 [005] "Flexible CO
cannot be performed.
proprietary telephone. Button Assignment."
6.1.4 Using Reset Button
.
..,
If the system does not operate properly, use the Reset Button.
(If Master and Slave Systems are in operation by System
Connection for KX-TD1232, reset both systems.)
Before using the Reset Button, try the system feature again to
confirm whether there definitely is a problem or not.
Notes:
(a) 'When the S ystem Clear Switch is set to "NORMAL," pressing
the Reset Button causes the following:
1. Camp-on is cleared.
2. Calls on Hold are terminated.
3. Calls on Exclusive Hold are terminated.
4. Calls in progress are terminated.
5. Call Park is cleared.
Other data stored in memory except the above are not cleared.
Troubleshooting 6-5