Cpc Signal Detection Outgoing Set - Panasonic KX-TD816 Installation Manual

415
45
l
CO Line Programming
CPC Signal Detection Outgoing Set
Description
Enables or disables CPC Signal Detection during the time between
the originated CO call and the established CO call. If this is
enabled, the system disconnects the line with the time set in
program [405] "CPC Signal Detection Incoming Set" when CPC
Signal is detected.
Selection
l
CO line number:
KX-TD816;
01 through 08, * ( *
=a11 CO lines)
KX-TD1232;
01 through 24, * ( *
=a11 CO lines)
l
Enable
(detection) /
Disable
(no detection)
Default
Disable
Programming
1.
2.
Enter 415.
Display: CPC Outgoing Asn
Press
NEXT.
3.
4.
5.
6.
Display: CO Line NO?->
Enter a CO
line number.
To
enter CO line number 01, you can also press NEXT.
Display example: C001:Disable
Keep pressing
SELECT
until the desired selection is
displayed.
Press
STORE.
To program another CO line, press
NEXT
or
PREV,
or
SELECT
and the desired CO
line number.
7.
Repeat steps 4 through 6.
8.
Press
E,W.
Conditions
l
Some central offices (CO) may send CPC-like signals during the dialing
sequence and an attempt to make a call may be terminated. If your CO
is such a type. select "Disable."
l
Program [405] "CPC Signal Detection Incoming Set" is used to set
CPC Signal Detection Time.
l
In the case of KX-TD1232, COO1 through CO12 are for the Master
System and CO 13 through CO24 are for the Slave, if available.
l
To assign all CO lines to one selection, press the * key at step 3. In
this case, the display shows the contents programmed for COO 1.
Feature References
Section 3, Features,
Calling Party Control (CPC) Signal Detection
* Direct Inward System Access (DISA)
4-94 System Programming *: Available for KX-TD 1232 only.