Configuring Mother Board Jumpers - NEC Express5800 series User Manual

CONFIGURING MOTHER BOARD JUMPERS

With the pre-installed SETUP utility, you can set desired passwords to protect the data stored in the
server against access from unauthorized users. When you forget the passwords, however, you may
want clear them. The following describes how to clear these passwords. You can also use the
following procedure to clear the CMOS data in the server.
IMPORTANT:
configuration data.
To clear passwords or the CMOS data, use the jumper switch on the mother board of the server. The
following figure illustrates the jumper switch location.
IMPORTANT:
may cause the CPU blade to fail or malfunction.
Pins for protecting/clearing the passwords
Short-circuit these two pins to clear the passwords.
Open these two pins to protect the passwords (factory-set).
Pins for protecting/clearing the CMOS data
Short-circuit these two pins to clear the CMOS data.
Open these two pins to protect the CMOS data (factory-set).
Clearing the CMOS data resumes the factory-set
Do not change any other switch settings. Any change
Configuring Your Server 4-43
: Strapped
Pins for protecting/clearing
the CMOS data.
(Shown here is factory-set
jumper setting.)