NEC Express5800 series User Manual page 116

5-6 Installing the Operating System
Installation of Windows Server 2003
Install Windows Server 2003 in the following procedure.
1.
Insert the Windows Server 2003 CD-ROM into the USB CD-ROM disk drive connected
to the CPU blade.
2.
Turn on the power to start the CPU blade.
3.
Press F6 while the message "Setup is inspecting your computer's hardware
configuration..." appears at the top of the screen.
NOTES:
In this status, pressing F6 cannot change the screen display at all.
Conduct key entries when the access lamp on the USB floppy disk
drive is off (or access to the floppy disk does not occur).
The following steps are not required if the key F6 may not be pressed. Provide the setup
depending on the directions on the screen. Refer to the "First Step Guide" for details.
4.
If the following message appears, press S.
Setup could not determine the type of one or more mass storage
devices installed in your system, or you have chosen to
manually specify an adapter. Currently, Setup will load
support for the following mass storage devices.
The following message appears.
manufacturer-supplied hardware support disk
5.
Insert the N8460-001 Driver FD into the floppy disk drive and press Enter.
The driver for the USB CD-ROM drive appears.
6.
Select "USB driver" and press Enter.
NOTE: Conduct key entries when the access lamp on the USB floppy
disk drive is off (or access to the floppy disk does not occur).
Please insert the disk labeled
into Drive A:
* Press ENTER when ready.