Problems With Nec Expressbuilder; Problems With Master Control Menu - NEC Express5800 series User Manual

Problems with NEC EXPRESSBUILDER

When the server does not boot from the NEC EXPRESSBUILDER CD-ROM, check the following:
Did you set the NEC EXPRESSBUILDER during POST and restart the server?
→ If you do not set the NEC EXPRESSBUILDER during POST and restart the
server, an error message will appear or the OS will boot.
Is the BIOS configuration correct?
→ The boot device order may be specified with the BIOS setup utility of the server.
Use the BIOS setup utility to change the boot device order to boot the system from
the CD-ROM drive first.
<Menu to check: [Boot]>
Has an error message appeared?
→ When an error occurs while the NEC EXPRESSBUILDER is in progress, the
following message appears. After this message appears, check the error and take
the appropriate corrective action according to the message listed in the table
below.
This machine is not supported.
NvRAM access error
Hard disk drive access error

Problems with Master Control Menu

The master control menu fails to appear:
Is your system Windows NT 4.0 or later, or Windows 95 or later?
→ The CD-ROM Autorun feature is supported by Windows NT 4.0 and Windows 95.
The older versions do not automatically start from the CD-ROM.
Is the Shift key pressed?
→ Setting the CD-ROM with Shift pressed down cancels the Autorun feature.
Is the system in the proper state?
→ The menu may not appear depending on the system registry setting or the timing
to set the CD-ROM. In such a case, start the Explorer and run \MC\1ST.EXE in
the CD-ROM.
Message
Troubleshooting 8-15
Cause and Remedy
This NEC EXPRESSBUILDER version is not
designed for this server. Execute the NEC
EXPRESSBUILDER on the compliant server.
An access to the nonvolatile memory
(NvRAM) is not acceptable.
The hard disk drive is not connected or it has
failed.
Check whether the hard disk drive is
correctly connected.