Displaying Array; Terminating Scsiselect - NEC Express5800 series User Manual

Displaying Array

To display an array, select the array and press Enter. The window of the detailed information on
hard disk drives appears. You can check the condition of each hard disk drive on this window as
follows:
Optimal: No malfunction
Building: The drive is the target one being subject to the rebuild operation.
Verify: The consistency of the redundant data stored in the array with fault-tolerant feature
is checked.
The information notifying that no drives are found indicates that no members are found and that the
array is not optimized.

Terminating SCSISelect

To terminate SCSISelect, press Esc several times until the termination message appears. Select
[Yes] to terminate SCSISelect and press any key to reboot the system. The modifications done in
SCSISelect are validated after the system is rebooted.
Configuring Your Server 4-31