Table of Contents
Advertisement
15.5 Setting the network
parameters on the L240
LAN Interface L240/IP
In the example configuration, the following IP addresses are assumed (can
vary according to the network):
PC:
192.168.3.1
L240/IP:
192.168.3.3
Gateway:
192.168.3.4
Generally, the properties of the Internet protocol for the PC settings are set
to "Obtain an IP address automatically". This setting must be checked and a
fixed IP address setting may need to be set.
The following example shows how the IP address of the computer is
changed (Example: Windows XP).
Note: The settings must be made by a person with appropriate experience
in the configuration of PCs and network technology. Consult your system
administrator if required.
Access the network settings:
Start – Control Panel - Network and Internet Connections
Double click on the respective network connection under LAN or High-
Speed Internet and click on Properties.
The window >Properties of LAN Connection opens.
Select Internet Protocol (TCP/IP) from the list and click on Properties.
Activate "Use the following IP address" and enter the new IP address (in
our example the IP address 192.168.3.1) and Subnet Mask.
IMPORTANT: Note the old IP setting so that you can reactivate it!
The IP addresses and further specification must correspond with one
another in the Intrusion Alarm Panel and in WIN-PC.
In menu Remote (Engineer menu "7=Remote"), select the function
"01=Connection". In this submenu, the connection is activated and the
type of communication is set. Select "Ethernet".
Connection
Off/On-On
Connection
Type-Ethernet
In submenu "02=Enable", the "Auto" parameter should be selected.
Operations
Enable-Auto
In submenu "03=Auth Code", an enable code can be entered. As enable
occurs without code, this function is not relevant and no entries must be
made.
Auth Code
Auth Code-000
1
Press button
to switch on the connection
2
Press button
to set type=Ethernet
2
Press button
to set enable to "Auto"
106
Advertisement
Table of Contents
