Table of Contents
Advertisement
Submenu "07=Gateway IP"
Submenu
"08=Subnet Mask"
Submenu
"09=GSR 1 S/N"
Submenus
"10...12 (GSR 2..4 S/N)"
7.1.8
Menu 8 "Edit"
Engineer-PIN
1 = Time/Date
2 = Tamp.Reset
3 = Test
4 = Change PIN
5 = Printer
6 = Service
7 = Remote
8 = Edit
9 = Cct Off
7.1.9
Menu 9 "Cct Off"
Engineer-PIN
1 = Time/Date
2 = Tamp.Reset
3 = Test
4 = Change PIN
5 = Printer
6 = Service
7 = Remote
8 = Edit
9 = Cct Off
Operation by the Engineer
In submenu "07=Gateway IP" the connection to the panel via a gateway
can be entered, here the Gateway IP address (dependent on the local
Ethernet settings). If the panel is connected via a local network or directly to
the PC (crossover cable), the value "0" can be entered here.
Gateway IP
192.168.3.4
In submenu "08=Subnet Mask" the range of devices that can be contacted
is defined. The setting must be compatible to the network used.
Subnet Mask
255.255.255.0
In submenu "GSR 1 S/N" a license number must be entered. For the
Intrusion Alarm Panel L240, an entry of 00000000 (8 zeros) is necessary.
GSR 1 S/N
00000000
The other submenus 10...12 (GSR 2..4 S/N) are not used.
Menu item "8=Edit": Using this menu item, access to the comprehensive
programming and configuration submenu of the panel (see chapter 8) is
undertaken.
Menu item "9=Cct Off": A circuit can be switched off fully and is no longer
subject to evaluation by the Intrusion Alarm Panel. This "emergency
shutdown" is registered in the event log.
Caution: A circuit, which has been switched off, no longer has any functions!
Circuit Off
Number _ _
Cct x
Off
Entry of the gateway address
Enter:
255.255.255.0
Enter 00000000 (8 zeros)
Enter the number of the circuit
Enter: 0=OFF; 1=ON
43
Advertisement
Table of Contents
