Table of Contents
Advertisement
7.1.5
Menu 5 "Printer"
Engineer-PIN
1 = Time/Date
2 = Tamp.Reset
3 = Test
4 = Change PIN
5 = Printer
6 = Service
7 = Remote
8 = Edit
9 = Cct Off
Submenu "1=Set Up"
Submenu
"2=Config"
Submenu
"3=Changes"
Submenu
"4=Text"
Operation by the Engineer
Menu item "5=Printer": The complete configuration of the Intrusion Alarm
Panel (incl. the SafeKey chip key/keypad code) can be printed out, and the
print parameters can be set. A serial Interface Module L208/V.24 and a
serial printer are required for printing. Alternatively, the serial print data can
be "read", processed and printed out on a PC or Laptop with the Interface
Module L208/V.24 via a serial interface (e.g. COM1) (see chapter 14.4
"Serial connection").
1=Set Up
2=Config
3=Changes
4=Text
5=Key/Code
6=Cancel Print
In submenu "1=Set Up" the print parameters for the serial print out are set.
Further information (e.g. Addressing or Settings) can be found in the see
chapter 14.4 "Serial connection".
Baud rate
The selected baud rate must correspond with the set baud rate of the
printer or PC/Laptop.
Printer
Baud-9600
Real Time
The parameter can be activated if the printer is always in service (Real
Time) and all data stored in the event log should also be printed out.
Printer
Real Time-Off
In submenu "2=Config" the entire system configuration and programming
can be printed out (incl. connected hardware, users, properties of the circuits
and Evaluation Modules L240/BS).
Printing
X=Cancel
In submenu "3=Changes" only the modified programming is printed out.
Printing
X=Cancel
In submenu "4=Text" all stored text for the circuits, user PIN codes, keypad
codes/chip keys and Evaluation Modules L240/BS is printed out.
Printing Text
X=Cancel
Display and selection of the baud rate
Enable Real Time: Parameter=ON
39
Advertisement
Table of Contents
