Table of Contents
Advertisement
6.2.3
Button 3 "Disp Cct Off"
6.2.4
Button 4 "Input PIN"
6.2.5
Button 5 "Disp Cct
Fault"
Operation of the L240
3
shows when the detector circuit is switched off. Both the internally
Button
set as well as the externally set switched off circuits are displayed. You can
><
page using the
buttons. Only the switched off circuits, which are located
in the same area as the keypad, can be displayed.
Cct 2
Off
All switched off circuits appear on the display, e.g. circuit 02 is switched off
and does not trigger an alarm. If a text is assigned for the circuit, it will be
displayed.
4
is used for entering a 4-digit user code to gain access to access
Button
level 1. The code entry is acknowledged with button
state the user PIN number 1 is enabled and set to "1111". In total up to
seven user PINs can be enabled (see menu item "08 = User Auth", chapter
8.1.8). Every access is stored along with the user number in the event log.
Input PIN:
5
displays malfunctioning / open circuits. Detector circuits of type
Button
"Intrusion" and "Personal attack" are displayed. You can page using the
buttons. Only the interrupted detector circuits, which are located in the same
area as the keypad, can be displayed.
Cct 5
Fault
On the display all malfunctioning detector circuits appear, e.g. circuit 05. If a
text has been assigned for the circuit, it will be displayed.
If a circuit malfunctions, after button
stored signals appears (e.g. glass break detector).
4= Reset
!
. In the default delivery
X
is pressed the prompt for deleting any
><
27
Advertisement
Table of Contents
