Table of Contents
Advertisement
9
Management of the chip key/keypad code
9.1
General
SafeKey
The management of all keypad codes and chip keys (e.g. learn or delete)
and their authorizations (e.g. access, set/unset operations) is undertaken on
the Intrusion Alarm Panel L240 with the LCD Keypad L240/PT in the
"Management" menu. The access to the "Management" menu is undertaken
using the 6-digit management code on the LCD Keypad L240/PT. The code
is set by factory default to "999999". By this method of direct access without
entry of a 4-digit user PIN code, the management of the keypad code and
chip key is thus undertaken by the user or the Engineer of the Intrusion
Alarm Panel. The management encompasses all areas and refers to the
Evaluation Module L240/BS and chip key or keypad code in all security
areas.
Deleting the keypad code and chip key is also possible in the user level.
After entry of the 4-digit user PIN No. 1 (factory default "1111") you access
the user level and can delete the keypad code and chip key as in the menu
"Management".
WELT/A
Note:
In order to manage the keypad codes and chip key, at least one
Evaluation Module L240/BS must be connected and logged on.
For "detection" and "learning" of a keypad code or chip key,
communication between an evaluation module and door cylinder, strike
plate or wall reader must be provided.
If the panel is in "learn mode", no door can be opened from outside via a
strike plate or door cylinder! However, the door can still be opened from
inside by another person.
The 3-digit code/key number is necessary to change or delete the keypad
code and chip key. It is assigned when learning in a keypad code or chip
key by the Intrusion Alarm Panel and should be noted accordingly (e.g. in
the table provided in the manual "Evaluation Module L240/BS").
Wall reader
WEL/A
Chip key
65
Advertisement
Table of Contents
