Table of Contents
Advertisement
Configuration and Programming by the Engineer
8.1.10 Menu 10 "L240/B/BS"
Engineer-PIN
8 = Edit
01 = System Size
02 = Area Opts
03 = Circuits
04 = Relay
05 = Alarm Times
06 = Keypads
07 = Concs *
08 = User Auth
09 = Text
10 = L240/B/BS*
11 = XS/1.1 KNX *
13 = 2-Conc Tamper *
15 = Defaults
16 = XIB-Detectors
8.1.11 Menu 11 "XS/S1.1 KNX"
Engineer-PIN
8 = Edit
01 = System Size
02 = Area Opts
03 = Circuits
04 = Relay
05 = Alarm Times
06 = Keypads
07 = Concs *
08 = User Auth
09 = Text
10 = L240/B/BS*
11 = XS/1.1 KNX *
13 = 2-Conc Tamper *
15 = Defaults
16 = XIB-Detectors
Example: Change the text for circuit 1.
Select submenu "1=Cct 1".
Circuit
Number _ _
Circuit 1
Cct 1
The first character flashes. Using the arrow keys you can advance in the text
line and jump to the next text position with the Enter button.
Menu item "10=L240/B/BS": The Evaluation Module L240/BS is assigned
to area 1 after it has registered. In this menu, the other areas can be
assigned. Refer to chapter 12 "SafeKey Evaluation Module L240/BS.
Menu item "11=XS/S1.1 KNX": The state of all 80 circuits of the panel as
well as other panel states such as the setting states, the alerting and the
signal devices can be monitored on the KNX system.
Each of the 80 circuits can also be contacted via the KNX. At the same time,
the setting can be undertaken via the KNX bus, and the alarm systems can
be reset via the KNX.
Every function, which allows access to the intrusion alarm system, can be
inhibited individually.
Communication to the KNX:
XS/S1.1 KNX
Standard
1=Standard VdS: Bidirectional communication.
2=Outputs Only, the panel is inhibited in the KNX system.
Enables (only with standard communication):
Inhibit or enable external setting:
XS/S1.1 KNX
Ext Set-Off
Enter the circuit number
(text used up to now is displayed)
(1=Standard; 2=Output Only)
(0=Off;1=On)
62
Advertisement
Table of Contents
