Toshiba e-studio200l Service Handbook page 424

(3) Fix the adjustment screws in the position as shown in the figure.
• Dogleg image A
Install the adjustment screws as shown in the figure below so that the stay of the fuser unit
can move upward.
Adjustment screws
• Dogleg image B
Install the adjustment screws as shown in the figure below so that the stay of the fuser unit
can move downward.
Adjustment screws
(4) Check the copied image. If further adjust-
ment is needed, fix the adjustment screws in
the position as shown in the figure so that the
stay can be moved both upward and down-
ward by 1 mm.
Be sure to make the scales on the right and
left match when installing the adjustment
screws.
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
ADJUSTMENT
Dogleg image A:
Installation position of the adjustment screws
Fig. 3-142
Dogleg image B:
Installation position of the adjustment screws
Fig. 3-143
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
3 - 104
Scale
Fig. 3-144