[CDC0] Punch power failure occurred abnormality
MJ-1025
Is the problem solved by turning the power of the equipment OFF and ON?
YES End
NO
Is the wiring between the finisher controller PC board and punch controller PC board cor-
rect?
NO
YES
Does the voltage between the CN14-5 (+) and CN14-3 (-) on the finisher controller PC
board become 24 V?
YES Replace the punch controller PC board.
NO
Replace the finisher controller PC board.
[CDD0] Folding sensor abnormality
MJ-1025
Is the folding position sensor (PI10) working properly?
NO
YES
Is the wiring between the finisher controller PC board and folding position sensor (PI10) cor-
rect?
NO
YES
Is there any mechanical problem with the fold jam releasing dial?
YES Fix the mechanism.
NO
1) Replace the staple/fold motor (M7).
2) Replace the finisher controller PC board.
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
TROUBLESHOOTING
Correct the wiring.
Replace the sensor.
Correct the wiring.
5 - 74
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved