[CC80] Front jogging plate motor abnormality/Alignment motor (front) abnormality
MJ-1022 (Front jogging plate motor abnormality)
Is the front jogging plate home position sensor (S6) working properly?
NO
YES
Is the wiring between the finisher controller PC board and front jogging motor (M3) correct?
NO
YES
Has the rack run over the stopper of the roll?
YES Fix it.
NO
1) Replace the front jogging motor.
2) Replace the finisher controller PC board.
MJ-1025 (Alignment motor (front) abnormality)
Is the aligning plate home position sensor (front) (PI4) working properly?
NO
YES
Is the wiring between the finisher controller PC board and alignment motor (front) (M4) cor-
rect?
NO
YES
Is there any mechanical problem with the path of aligning plate?
YES Fix the mechanism.
NO
Try replacing the alignment motor (front) (M4). Is the problem corrected?
YES End.
NO
Replace the finisher controller PC board.
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
TROUBLESHOOTING
Replace the sensor.
Correct the wiring.
Replace the sensor.
Correct the wiring.
5 - 70
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved