[Procedure 2]
Is the staple/fold motor clock sensor (PI14) working properly?
NO
YES
Does the staple/fold motor operate at the appropriate timing?
YES Replace the finisher controller PC board.
NO
Is the stapler unit drive mechanism working properly?
NO
YES
Try replacing the staple/fold motor (M7). Is the problem corrected?
YES End.
NO
Replace the finisher controller PC board.
[Procedure 3]
Is the folding home position sensor (PI11) working properly?
NO
YES
Is the wiring between the finisher controller PC board and the staple/fold motor normal?
NO
YES
Try to rotate the fold jam releasing dial. Is there mechanical trapping?
YES Fix the mechanism.
NO
Try replacing the staple/fold motor (M7). Is the problem corrected?
YES End.
NO
Replace the finisher controller PC board.
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
Replace the sensor.
Fix the mechanism.
Replace the sensor.
Correct the wiring.
5 - 65
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
TROUBLESHOOTING
5