Toshiba e-studio200l Service Handbook page 608

<Updating Finisher ROM>
(1) Install the ROM to the download jig.
Make sure the direction is correct (P.6-4 "Fig. 6-3").
(2) Turn OFF the power of the equipment.
(3) Take off the finisher rear cover.
* Connect the finisher interface cable with the equipment after removing the finisher rear cover.
(4) Connect the download jig with the jig connector on the finisher control PC board.
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
FIRMWARE UPDATING
Finisher rear cover
Fig. 6-29
Connector
Fig. 6-30
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
6 - 28