Toshiba e-studio200l Service Handbook page 516

[CB20] Delivery motor abnormality
MJ-1022
Rotate the delivery roller by hand. Does it rotate smoothly?
NO 

YES
Is the wiring between the finisher controller PC board and delivery motor (M1) correct?
NO 

YES
Is the delivery motor clock sensor (S1) working properly?
NO 

YES
1) Replace the delivery motor (M1).
2) Replace the finisher controller PC board.
MJ-1025
Is the delivery belt home position sensor (PI7) working properly?
NO 

YES
Is the wiring between the finisher controller PC board and delivery motor (M3) correct?
NO 

YES
Rotate the stack delivery roller by hand. Does it rotate smoothly?
NO 

YES
Try replacing the delivery motor (M3). Is the problem corrected?
YES  END.

NO
Replace the finisher controller PC board.
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
TROUBLESHOOTING
Fix the mechanism.
Correct the wiring.
Replace the sensor.
Replace the sensor.
Correct the wiring.
Fix the mechanism.
5 - 62
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved