Toshiba e-studio200l Service Handbook page 527

[CCB0] Rear jogging plate motor abnormality/Alignment motor (rear) abnormality
MJ-1022 (Rear jogging plate motor abnormality)
Is the rear jogging plate home position sensor (S7) working properly?
NO 

YES
Is the wiring between the finisher controller PC board and rear jogging motor (M4) correct?
NO 

YES
Has the rack run over the stopper of the roll?
YES  Fix it.

NO
1) Replace the rear jogging motor.
2) Replace the finisher controller PC board.
MJ-1025 (Alignment motor (rear) abnormality)
Is the aligning plate home position sensor (rear) (PI5) working properly?
NO 

YES
Is the wiring between the finisher controller PC board and aligning plate home position sen-
sor (rear) correct?
NO 

YES
Is there any mechanical problem with the path of aligning plate?
YES  Fix the mechanism.

NO
Try replacing the alignment motor (rear) (M5). Is the problem corrected?
YES  End.

NO
Replace the finisher controller PC board.
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
Replace the sensor.
Correct the wiring.
Replace the sensor.
Correct the wiring.
5 - 73
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
TROUBLESHOOTING
5