[A] Update Procedure
Since the procedure differs depending on the data, see the each procedure below.
Important:
•
Turn OFF the power before installing or removing the download jig.
•
Do not turn OFF the power during the update. The data could be damaged and not be oper-
ated properly.
<Updating Engine ROM>
(1)
Install the ROM to the download jig.
Make sure the direction is correct (P.6-4 "Fig. 6-3").
(2)
Turn OFF the power of the equipment.
(3)
Take off the connector cover.
(4)
Remove the cover plate.
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
Connector cover
Fig. 6-20
Cover plate
Fig. 6-21
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
6 - 23
FIRMWARE UPDATING
6