Toshiba e-studio200l Service Handbook page 498

[EAF0] Stack return jam
MJ-1022
Is there any paper remaining on the transport path in the finisher or equipment?
YES  Remove the paper.

NO
Is the connector J10 on the finisher controller PC board disconnected?
Is the harness connecting the finisher controller PC board and returning roller home position
sensor (S3) open circuited?
YES  Connect the connector securely. Replace the harness.

NO
Is the returning roller home position sensor working properly?
l NO 
l

YES
Replace the finisher controller PC board.
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
TROUBLESHOOTING
1) Connect the connector of the returning roller home position sensor
securely.
2) Replace the returning roller home position sensor.
5 - 44
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved