Siemens sinumerik 840D sl Function Manual page 471

Detailed description
2.1 Loadable compile cycles 840D/840D sl
When you order one of the listed technological functions, you are given the corresponding
software license number. To obtain the required compile cycle in the form of a loadable file
(extension .ELF for executable and linking format), please contact your regional Siemens
sales partner.
Note
Compile cycles created by Siemens are options that require explicit activation and licensing.
References: Ordering information in Catalog NC 60/61
2.1.1 Loading a compile cycle with HMI Advanced
Requirement
To transfer the compile cycle to the control, the following requirements must be met:
A storage medium (e.g. USB FlashDrive), which stores the compile cycle, is connected to
the PCU.
Execution
Perform the following operation to load a compile cycle from a USB FlashDrive into the NCK:
1. Insert the USB FlashDrive into the PCU 50/70.
2. Open the USB FlashDrive as a local drive:
3. Select the compile cycle and copy it:
4. Go to the OEM Directory of the NC Card:
5. Add the compile cycle to the NC card's OEM directory:
6. Trigger a NCK reset to load the compile cycle into the NCK system software.
10
Operating area changeover > Services > Manage Data > USB local
If the "USB local" softkey is grayed out, then the USB FlashDrive has not yet been
detected. Wait until HMI Advanced has detected the USB FlashDrive.
Vertical softkey "Copy"
etc-key ">" > NC-Card > Directory: "cc" or "Loadable Compile Cycles"
Vertical softkey "Add"
Special functions: Installation and Activation of Loadable Compile Cycles (TE01)
Function Manual, 11/2006, 6FC5397-2BP10-2BA0