Remove And Replace The Ballast/Power Supply Insulator - Toshiba TDP-MT8 Service Manual

Remove and Replace the Ballast/Power Supply Insulator

The ballast/power supply insulator provides electrical insulation between the power supply, ballast and
chassis.
WARNING The insulator must always be installed between the ballast and power supply and the chassis.
Inspect the gasket closely whenever the ballast or power supply is removed. Never use a
gasket with holes or tears.
The lamp connector retainer fastens to the chassis near the thermal switch. It holds the lamp connector
securely in the lamphouse.
1. Remove the following items:
Ballast (see page 7)
Power supply (see page 43)
2. Tilt the ballast/power supply insulator away from the front wall of the chassis and the ballast
mounting standoffs. Then lift the insulator out of the projector.
Assembly Notes
♦
Position the ballast/power supply insulator in the chassis so that the holes in the bottom of the
insulator align with the ballast mounting slots and power supply standoffs that protrude from the floor
of the chassis. Then press the insulator over the ballast mounting standoffs on the front of the
chassis.
TDP-MT8 Service Guide 10