Toshiba TDP-MT8 Service Manual page 18

7. If you are replacing the controller with a new one, remove the I/O EMI shield (see page 35).
Assembly Notes
♦
Align the controller/DMD connector, then press the controller down firmly. You will feel the connector
halves engage.
♦
Use a T-10 driver to install the seven M3x8 Torx screws. Torque the screws to 6 in-lbs (.68 Nm).
♦
Plug in the controller/power supply cable.
♦
Plug in the two fan cables, the front, rear and two side IR receiver cables, the photodiode cable, the
light tunnel heater cable, and the color wheel ribbon cable. Go to page 88 if you need help with the
color wheel ribbon cable.
TDP-MT8 Service Guide 18