Toshiba TDP-MT8 Service Manual page 25

3. Remove the three M3x8 Torx screws that fasten the mounting bracket to the bottom case.
4. Lift the bracket at the front and remove it from the bottom case.
Assembly Notes
♦
Place the rear of the mounting bracket beneath the lip at the front of the chassis.
♦
Make sure the bracket aligns with the holes in the bottom case. Torque the three M3x8 Torx screws
to 6 in/lbs (.68 Nm).
♦
Torque the M3x8 Torx screw at the front of the chassis to 6 in/lbs (.68 Nm).
TDP-MT8 Service Guide 25