Remove And Replace The Top Case - Toshiba TDP-MT8 Service Manual

Remove and Replace the Top Case

The top case covers the top half of the half of the projector. Once you remove the top case, you have
access to FRUs inside the projector. When you replace the top case, you need to adhere a new
nameplate to the top case.
A new top case contains two speakers. You cannot remove the speakers from the top case.
1. Remove the following items:
Rear bezel (see page 51)
Outer handle (see page 41)
2. Place the projector right side up on the bench, and then remove the two black M3x8 Torx screws
from the bottom case.
3. Slowly lift the top case away from the projector. Avoid stress on the cables that run between the
top case and controller ECA.
TDP-MT8 Service Guide 57