Remove And Replace The Chassis - Toshiba TDP-MT8 Service Manual

Remove and Replace the Chassis

The metal chassis provides the necessary rigidity for the projector's internal components, yet it adds
very little to the overall weight. The power supply, ballast, rear IR receiver, lamp connector retainer
and safety switch fasten to the chassis. The ballast/power supply insulator provides electrical
insulation between the chassis and components inside it.
1. Remove the following items:
Lamp module (see page 37)
Outer handle (see page 41)
Rear bezel (see page 51)
Top case (see page 57)
Controller ECA (see page 16)
Rear IR receiver (see page 47)
2. Remove the four M3x8 Torx screws that fasten the chassis to the bottom case.
TDP-MT8 Service Guide 13