2.
Use a Philips screwdriver to remove the shaft from inside the bottom case.
Assembly Notes
♦
The end of the leveling foot shaft is keyed to fit the leveling foot knob. Make sure the knob properly
fits the key on the shaft before inserting the screw.
♦
Torque the M3x8 Plastite Torx screw to 4 in.-lbs. (.45 Nm).
♦
Press the rubber foot into the hole over the screw head. Use a replacement rubber foot if the
adhesive fails to hold the old foot tightly in place.
♦
Adjust the leveling foot knob to be level with the bottom of the projector.
TDP-MT8 Service Guide
40