Remove And Replace The Lamp Door And Lamp Module - Toshiba TDP-MT8 Service Manual

Remove and Replace the Lamp Door and Lamp Module

The lamp door fits over the lamp cavity in the projector. It includes a tab that closes the interlock switch
when the door is shut.
The lamp module consists of a metal housing and enclosed reflector assembly and arc tube. A blower
on the side of the lamp module provides cooling air to the arc tube and reflector inside of the housing.
CAUTION The lamp module gets very hot during operation. Allow the lamp to cool for 30 minutes before
handling it. The lamp module gets very hot during operation. Allow the lamp to cool for 30
minutes before handling it.
1. Place the projector upside down on a soft work surface.
2. To remove the lamp door, loosen the two captive screws that secure it to the projector.
TDP-MT8 Service Guide 37