6.
Place the chassis on the bench and remove the following parts:
Safety switch (see page 55)
Power supply (see page 43)
Ballast (see page 7)
Ballast/power supply gasket (see page 10)
You are left with the bare chassis.
Assembly Notes
♦
Install the parts in the reverse order.
♦
Torque the two M3x6 Torx screws on the lamp connector retainer to 6 in/lbs (.68 Nm).
♦
Torque the five M3x8 Torx screws that secure the chassis in the projector to 6 in/lbs (.68 Nm).
TDP-MT8 Service Guide
15