Remove And Replace The Bottom Case - Toshiba TDP-MT8 Service Manual

Remove and Replace the Bottom Case

The bottom case encloses the bottom half of the projector. When you replace a bottom case, you also
need to adhere a new certification label.
1. Remove the following items:
Lamp door and lamp module (see page 37)
Outer handle (see page 41)
Rear bezel (see page 51)
Top case (see page 57)
Inner handle and front vent (see page 33)
Controller ECA (see page 16)
Fan assembly (see page 26)
Chassis (see page 13)
Optical engine (see page 22)
Optical engine mounting bracket (see page 24)
Side IR receivers and lenses (see page 47)
Rubber feet (see page 54)
Elevator (see page 19)
Leveling foot (see page 39)
2. Remove the serial number label from the certification label. To do this, carefully use a heat gun or
hair drier to soften the adhesive on the back of the label, then peel it off. Do not lose the serial
number. It is not a replaceable part.
TDP-MT8 Service Guide 11