Table of Contents
Advertisement
3.
Unplug the controller/power supply cable from the controller ECA. Squeeze the latch on the
bottom of the connector to release it.
4.
Remove the seven M3x8 Torx screws that fasten the controller ECA to the chassis.
5.
Lift the controller ECA over the optical engine to release the DMD/controller connector.
6.
Lift the controller out of the projector.
WARNING Make sure to store the controller ECA in a static-safe container.
TDP-MT8 Service Guide
17
- Quick Links:
- Power and Start-Up Problems
Hide quick links:
Advertisement
Table of Contents
