Toshiba TDP-MT8 Service Manual page 48

♦
Make sure that the rear IR receiver aligns with the hole in the chassis.
♦
Torque the two M3x8 Torx screws to 6 in/lbs (.68 Nm).
♦
Connect the cable to J518 on the controller ECA.
Left or Right Side IR Receivers and Lenses
The side IR lenses hold the left and right side IR receivers in the bottom case. You use the same
procedure to remove or replace either side IR receiver or lens.
1. Unplug the left side IR receiver from J508 or the right side IR receiver from J514 on the controller
ECA.
2. Gently pull upward on the lens tab to disengage the slot from the tab on the IR receiver.
TDP-MT8 Service Guide 48