Remove And Replace The I/O Emi Shield - Toshiba TDP-MT8 Service Manual

Remove and Replace the I/O EMI Shield

The I/O EMI shield fits over the I/O connectors on the rear of the controller ECA. It fastens to the
controller with eight jack screws.
1. Remove the following items:
Outer handle (see page 41)
Rear bezel (see page 51)
Top case (see page 57)
2. Remove the six 4-40 jack screws that fasten the EMI shield to connectors on the controller ECA.
3. Carefully pull the I/O EMI shield off of the connectors. Take care not to bend the shield or the
fingers as you work the shield off.
Assembly Notes
♦
Make sure the fingers on the shield contact the connectors.
♦
Torque the jack screws to 2 in-lbs (.226 Nm).
TDP-MT8 Service Guide 35