Siemens SINUMERIK 840D sl Function Manual page 448

Hide thumbs Also See for SINUMERIK 840D sl:

Table of Contents

10.1 Troubleshooting procedure

After the vertical "start" softkey is pressed, the measurement is started on the NCK

side. An appropriate note is output in the message line.

If the measurement cannot be started, appropriate error information is output. This

information can be used to pinpoint the problem.

Once the measurement has been completed, the results of the measurement can

be graphically displayed using the horizontal "display" softkey:

Two graphics (graphic 1 and graphic 2) are displayed. Each graphic can include up

to two measured value curves that are color–coded (trace 1 in graphic 1: green,

trace 2 in graphic 1: blue, trace 3 in graphic 2: green, trace 4 in graphic 2: blue)

Trace 1 and trace 2 are displayed in graphic 1, trace 3 and trace 4 in in graphic 2.

The X axis of the graphics is the time axis and the Y axis is scaled in the physical

units of the particular signal.

File functions

Measurement settings and the measured values of the servo trace functions can

be saved, downloaded or deleted using the horizontal softkey "File functions".

SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 05.2008 Edition

Sinamics s120