ABB i-bus KNX Product Manual page 130

®
ABB i-bus KNX
Commissioning
Enable automatic operation
Options:
Yes: Automatic operation is enabled. The
appears.
Enable direct operation
Options:

Yes: Direct operation is enabled. The
Set startup/run-on
Options:

Yes: The function Set startup/run-on is enabled. The
appears.
128 2CDC508134D0202 | FCA/S 1.x.x.1
Limitation on forced operation
Options: 3, 2, 1, OFF
Unchanged
OFF
1
1, OFF
2
2, 1
2, 1, OFF
3
3, 2
3, 2, 1
This parameter sets which fan speed is set, or may not be over/undershot, when forced operation is
active.

3, 2, 1, OFF: All states are possible.

Unchanged: The state is retained.

OFF: Off

1: Limited to speed 1.*

1, OFF: limited to speed 1 and off.

2: Limited to speed 2.*

2, 1: limited to speeds 2 and 1.

2, 1, OFF: limited to speed 2, 1 and off.

3: Limited to speed 3.*

3, 2: limited to speeds 3 and 2.

3, 2, 1: limited to speeds 3, 2 and 1.
* The control value is ignored.
No
Yes
No
Yes
No
Yes
Parameter window Automatic control
Parameter window Direct
Parameter window
(Multi-level), p. 137, also
operation, p. 143, also appears.
Startup/Run-on, p. 145, also