ABB i-bus KNX Product Manual page 221

®
ABB i-bus KNX
Commissioning
No.
61
This communication object is enabled if the parameter Enable limitations has been selected with the option Yes in
window Automatic control
The limitation 1 is active if a telegram with the value 1 is received on the communication object Limitation 1. The Limitation 1
is deactivated if a telegram with the value 0 is received on the communication object Limitation 1.
When Limitation 1 is activated, the fan can only assume the fan speed or speed range as set in the parameter Limitation 1.
Telegram value:
62
See communication object 61
63
See communication object 61
64
See communication object 61
Functionality
Limitation 1
(Multi-level), p. 137.
Note
Limitation 1 is only active in automatic operation.
0 = Limitation x inactive
1 = Limitation x active
Limitation 2
Limitation 3
Limitation 4
communication object name
Fan E, F, G
Data type Flags
1 bit C, W
DPT 1.003
Parameter
FCA/S 1.x.x.1 | 2CDC508134D0202 219