®
ABB i-bus
KNX
Planning and application
4.4.3
ETS reset
What is an ETS reset?
Generally an ETS reset is defined as a reset of the device via the ETS. The ETS reset is triggered in the
ETS under the menu item Commissioning with the function Reset device. This stops and restarts the
application.
4.4.4
Download
During a download, the output behaves just as it would on bus voltage failure.
Note
After a download with a change, the parameter reacts as if there has been an ETS reset.
If the application is downloaded again (full download) after a full discharge, the reaction is the same as
after an ETS reset.
After the application is removed or after an interrupted download, the device no longer functions.
FCA/S 1.x.x.1 | 2CDC508134D0202 253