Toshiba Stratagy IVP8 Installation And Maintenance Manual page 208

AMIS Networking
Configuring Stratagy for AMIS
Table 9-1 AMIS Parameters
Parameter
amis_diskfull
amis_enabled
amis_ltm
amis_max_attempts
amis_max_node
amis_rna
area_code
country_code
local_amis_node
phone_number
unknown_node_action
9-4
Percentage of the flash drive that must be free in order for Stratagy to accept new
AMIS messages. If free space is less than this figure, Stratagy tells the calling AMIS
system that the flash drive is full.
Default: 5 (To enable, remove the starting # and set the value.)
Whether Stratagy processes incoming AMIS calls.
True: Stratagy processes incoming AMIS calls.
False: AMIS calls told that this node is not accepting network calls.
Possible values: true, false
Default: true (To enable, remove the starting # and set the value.)
User ID to use for the AMIS Loopback mailbox. User ID mailbox other AMIS nodes
can use for testing the network. Any AMIS message to this mailbox is sent back to
the sender, if accessible from this Stratagy system.
Possible values: valid User ID. The single quotes are required.
Default: '989' (To enable, remove the starting # and set the value.)
Special retry count that keeps track of how many times this system was called
without a successful handshake after answer. If the count is exceeded, then the
gateway is disabled.
Possible values: 1~5
Default: 3 (To enable, remove the starting # and set the value.)
Maximum number of remote nodes (Gateway and Proxy mailboxes) that can be in
the network. If the actual number exceeds this value, some nodes are inaccessible.
Possible values: 1~256
Default: 256 (To enable, remove the starting # and set the value.)
Enables the ring no answer time-out to be increased to enable slow answers from
AMIS systems.
Possible values: 1~9
Default: 3 (To enable, remove the starting # and set the value.)
Area code of the resident Stratagy system. Single quotes are required.
Default: ' ' (To enable, remove the starting # and set the value.)
Country code of the resident Stratagy system. Single quotes are required.
Default: '1' (North America)
(To enable, remove the starting # and set the value.)
User ID of the Gateway box that represents the local AMIS node. Messages
addressed to this node are delivered directly to the real local box number instead of
being shipped out on the network.
Possible values: valid User ID.
Default: 0 (To enable, remove the starting # and set the value.)
Local telephone number of the resident Stratagy system. Single quotes are
required.
Default: ' ' (To enable, remove the starting # and set the value.)
Whether Stratagy accepts messages from unknown AMIS nodes.
1: Refuses to accept messages.
2: Delivers this message even though replies are impossible.
Possible values: 1, 2
Default: 2 (To enable, remove the starting # and set the value.)
Description
Stratagy I&M 06/02