Serial Port Definition (Remote Pc - Stratagy Admin); Amis Configuration; Smdi/Serial Integration Definition; Per Port Definitions - Toshiba Stratagy IVP8 Installation And Maintenance Manual

Parameter
stopbits1
stopbits2
Serial Port Definition (Remote PC — Stratagy Admin)
admin_port

AMIS Configuration

Audio Messaging Interchange Specification (AMIS) is the analog networking protocol that enables Stratagy to pass
voice messages to any remote voice mail system that supports the AMIS protocol.
See Table 9-1 on page 9-4 of

SMDI/Serial Integration Definition

Stratagy can enable Simplified Message Desk Interface (SMDI) protocol to provide a RS-232 integration with
telephone systems that also have SMDI capabilities. This integration is used with Centrex installations.
See Table 4-4 on page 4-33
parameters.

Per Port Definitions

box_grt
Stratagy I&M 06/02
Number of stop bits to use for logical serial port 1.
Possible values: 0, 1, 2
Default: 1
Number of stop bits to use for logical serial port 2.
Possible values: 0, 1, 2
Default: 1
In order for Stratagy to communicate with the Stratagy Admin PC connected to one
of its serial ports, Stratagy needs to know which port is to be used. This parameter
defines the logical port that Stratagy software uses.
Example: Set this parameter to 1 for logical serial port 1.
CAUTION! The connection may fail if the baud parameter for this port is set
higher than 9600 or the serial port definitions for this port do not
correspond to the definitions for the COM port being used on the
Stratagy Admin PC.
Possible values: 1 (COM1), 2 (COM2)
Default: 2
Chapter 9 – AMIS Networking
of "SMDI Serial Integration" on page 4-32
Sets the starting User ID for the port given as the last value.
Examples: box_grt 990 1 means that on port 1, a new call starts at User ID 990.
Possible values: valid User ID and valid port
Default: 990 1
990 2
.
.
.
990 8
Description
for complete descriptions of all AMIS parameters.
for complete descriptions of all SMDI
Configure Stratagy
System Parameters
4-29