System Integration Patterns - Toshiba Stratagy IVP8 Installation And Maintenance Manual

System Integration Patterns

If your telephone system supports integration, this selection controls the definition of its integration.
Perform this step only to refine, verify, or modify the integration of the Stratagy system with your
telephone system.
Some of the pre-defined telephone system dial codes already contain integration information, while
others are configurable.
Define the System Integration Pattern Fields
1. From the Tools menu, press 4. The Telephone System Configuration screen displays.
2. From the Telephone System
Configuration screen, press 2.
The System Integration
Patterns screen displays
(shown right).
3. Define Integration Timeout
by 1/10—amount of time
Stratagy waits for integration
information from the
telephone system.
Possible values: 0~99
(disable integration) (in 10ths
of seconds).
Suggested value: 10 (10 10ths = 1 second)
4. Define the remaining fields (i.e., integration strings) that Stratagy should match. Proceed to
"Define the Integration Strings Stratagy Matches" on page
See Table 4-3 for definitions.
5. After making the change(s), press ESC. The Telephone System Configuration screen displays.
6. From the Telephone System Configuration screen, press 1. The changes are transmitted to
Stratagy and Stratagy is shut down and restarted. By shutting down and restarting Stratagy, the
changes take effect.
...or 2.The changes are transmitted to Stratagy but Stratagy is not shut down or restarted. Until
you restart Stratagy, the changes do not take effect.
...or 3. The changes you made are cancelled and not saved.
7. If you pressed 1 to save the changes, press any key to reboot. The DOS prompt displays. To
continue, you must re-enter Stratagy Admin.
Stratagy I&M 06/02
Configure Stratagy
4-11.
Tools Utility
4668
4-9