Strata Dk Systems - Toshiba Stratagy IVP8 Installation And Maintenance Manual

Installation
Step 2: Program Strata
Important!
➤
Program slot in Strata CTX before installing the IVP8. Refer to Strata CTX Programming
Manual for details.
DSS/Busy Lamp Feature
Do you want to activate the DSS/Busy Lamp feature? PDKU/BDKU cards must be installed that is
programmed for a DSS Console.
➤
Install and program the PDKU/BDKU in the Strata CTX.
Refer to the Strata CTX Programming Manual for DSS programming.
Note See

Strata DK Systems

The Stratagy Voice Processing system works with all Strata DK40i/DK40/DK16e/DK16, DK424i/
DK424/DK280, and DK24/DK56/DK96 (Release 4) systems.
In addition, Flash works with the Strata DK14/DK8.
DTMF Signaling
Strata DK needs to recognize Stratagy's DTMF signaling. Make sure a K5RCU, K5RCU2 or
K4RCU3 is installed in the DK40i/DK40/DK16e/DK16, an RRCS on the DK424i/DK424/DK280
RCTU, or CRCU in the DK24/DK56/DK96.
➤
Run Program 03 and assign these code(s) where the DTMF receiver is installed:
DK40i/DK40/DK16e/DK16
Code 92 for slot 00
Flash
Make sure there are enough single line (analog) station ports on the Strata DK to support the number
of Flash ports required.
Note When DK14/DK8 is powered on, Program 03 automatically assigns the correct code for the
QRCU.
IVP8
The following instructions are based on the IVP8 being installed in a pre-existing
Note
Strata DK. If the Strata DK is a new installation, see First-time Programming in Chapter 1 –
Overview of the Strata DK Programming Manual for more information.
To the Strata DK processor, the IVP8 functions as an analog card (RSTU). Although there are
some special program settings required for the IVP8 (e.g., DSS/BLF feature), the Strata DK should
be programmed just as it would for any external voice mail system that is to be connected to it.
Important!
1. Using Program 03–Flexible PCB Slot Assignments set/verify the following slot assignments:
•
Set code 31 for the slot where IVP8 is installed (see
2-6
The Strata CTX may need to be reset to initialize some Strata programming
assignments. It is important that you make all such assignments before installing the
IVP8.
"Busy Station Identification for IVP8" on page 5-11
The Strata DK may need to be reset to initialize some Strata programming
assignments. It is important that you make all such assignments before installing the
IVP8.
DK424i/DK424/DK280
Code 92, 93, or 94 for slot 00
Step 4: "Install Stratagy"
for required settings on IVP8.
DK24/DK56/DK96
Code 92 or 93
on page
Stratagy I&M
2-7).
06/02