Ats10 Set Disconnect Delay After Indicating The Absence Of Data Carrier - Siemens Brodersen MC55 AT Command Manual

7.15 ATS10 Set disconnect delay after indicating the absence of data
carrier
Syntax
Read Command
ATS10?
Response(s)
<n>
OK
Write Command
ATS10=<n>
Response(s)
OK
ERROR
Reference(s)
V.250
Command Description
This parameter setting determines the amount of time, that the TA remains connected in absence of a data car-
rier. If the data carrier is detected before disconnect, the TA remains connected.
Parameter Description
(num)(&W)(&V)
<n>
number of tenths of seconds of delay
(&F)
001...2 ...254
MC55_ATC_V04.00
Confidential / Released
PIN ASC0 ASC1
! % !
Page 142 of 475
MUX1 MUX2 MUX3 Charge
% ! ! !
Last
! !
3/17/06