At^slcc Siemens Defined Command To List Current Calls Of Me - Siemens Brodersen MC55 AT Command Manual

7.21

AT^SLCC Siemens defined command to list current calls of ME

covers essentially the same information as GSM 07.07 command AT+CLCC, with the following addi-
AT^SLCC
tions:
• The execute command response contains an additional parameter
cating whether the call has been assigned a traffic channel by the network (transmission of data or inband
information is possible).
• The additional write command allows to activate Event reporting for the list of current calls. If event reporting
is active for an interface, a call status transition (cf.
assignment of a traffic channel will generate an event report indication to this interface. In order to receive
this event report as an URC, the URC presentation mode for this interface has to be configured with
AT+CMER.
The frequency of event report generation can be configured with AT command AT^SCFG. Refer to
Status Information
• The additional read command allows to determine the event reporting mode
interface receives event report indications for the list of current calls. Mind that the URC will be displayed only
if the URC presentation mode for the interface concerned has been configured with AT+CMER.
Syntax
Test Command
AT^SLCC=?
Response(s)
^SLCC: (list of supported<n>s)
OK
Read Command
AT^SLCC?
Response(s)
^SLCC: <n>
OK
Exec Command
AT^SLCC
Response(s)
[^SLCC:<idx>, <dir>, <stat>, <mode>, <mpty>,
<type>[, <alpha>]]]
[^SLCC:<idx>, <dir>, <stat>, <mode>, <mpty>,
<type>[, <alpha>]]]
[^SLCC:...]
OK
ERROR
+CME ERROR
Write Command
AT^SLCC=[<n>]
Response(s)
OK
ERROR
+CME ERROR: <err>
Reference(s)
Siemens
MC55_ATC_V04.00
Confidential / Released
for further detail on the configuration options.
Page 149 of 475
<traffic channel assigned>
Information) and (if desired) the
Call Status
<traffic channel
<traffic channel
PIN ASC0 ASC1 MUX1
% % % %
which indicates whether the
<n>
assigned>[, <number>,
assigned>[, <number>,
MUX2 MUX3 Charge
% % ! !
indi-
Call
Last
!
3/17/06