Leds On The Control Interface Board In The Smart Line Module - Siemens SINAMICS S120 Equipment Manual

Diagnostics

7.5 LEDs on the Control Interface Board in the Smart Line Module

7.5 LEDs on the Control Interface Board in the Smart Line Module
Table 7- 4 Meaning of the LEDs on the Control Interface Board in the Smart Line Module
LED, status
H200 H201
Off Off
Green Off
Orange
Red
Orange Orange
Red ---
Flashing, 0.5 Hz: ---
Green / Red
Flashing, 2 Hz: ---
Green / Red
Flashing, 2 Hz: ---
Green / Orange
or
Red / Orange
Irrespective of the status of LED "H201", hazardous DC link voltage may always be
present.
The warning information on the component must be carefully observed.
316
Description
The electronics power supply is missing or outside the permissible tolerance
range.
The component is ready for operation and cyclic DRIVE-CLiQ communication is
taking place.
The component is ready for operation and cyclic DRIVE-CLiQ communication is
taking place. The DC link voltage is present.
The component is ready for operation and cyclic DRIVE-CLiQ communication is
taking place. The DC link voltage is too high.
DRIVE-CLiQ communication is being established.
At least one fault is present in this component.
Note:
The LED is activated regardless of whether the corresponding messages have
been reconfigured.
Firmware is being downloaded.
Firmware download is complete. Wait for POWER ON.
Component detection using LED is activated (p0124).
Note:
Both possibilities depend on the LED status when activated using p0124 = 1.
WARNING
S120 Cabinet Modules Equipment Manual
Manual, (GH5), 10/2008, A5E00427098A