M06, Base 100 Mm High, Ral 7022 - Siemens SINAMICS S120 Equipment Manual

8.29

M06, base 100 mm high, RAL 7022

Availability of option
This option is available for the following S120 Cabinet Modules:
● Line Connection Module
● Basic Line Module
● Smart Line Module
● Active Line Module
● Motor Module in chassis format
● Booksize Base Cabinet
● Central Braking Module
● Auxiliary Power Supply Module
Description
Because it is raised 100 mm, the supplementary cabinet base allows for greater bending
radii for cables (cable inlet from below) and cable routing within the base.
The cabinet base comes completely assembled and is usually color RAL 7022.
Table 8- 41 Components of the cabinet base
Component
1 x base element (rear)
1 x base element (front)
Base covers
(option M26/M27 only)
4 x cover caps
Connection to the foundation
To connect the cable marshalling compartment to the foundation, four holes for M12 screws
are provided. These are in line with the holes in the cabinet. The fixing dimensions are
specified on the associated dimension drawings.
Connection for side-by-side installation of cabinet units
The individual bases are not connected for cabinet units installed in a side-by-side
configuration. The connection from the base to the cabinet and between the cabinet units
ensures sufficient stability.
Note
In transport units, the base covers inside the transport unit are only secured at the bottom
and are folded down parallel to the ground.
S120 Cabinet Modules Equipment Manual
Manual, (GH5), 10/2008, A5E00427098A
Connection element
8.29 M06, base 100 mm high, RAL 7022
Fixing elements
On the cabinet:
The cabinet base is shipped pre-assembled.
On the foundation:
The holes are in line with the holes in the
cabinet (see dimension drawings).
Options
419