Siemens Simatic Ident Function Manual page 126

Error messages
4.3 Errors from the communications module/reader
Error mes- Description
sage
(hex)
0xE4FE8C00
Communication error between Ident profile and communications module. Handshake error.
•
– UDT of this communications module is overwritten by other program sections
– Check parameter settings of communications modules in the UDT
– Check the Ident profile command that caused this error
– Start "INIT" after correcting the error
Backplane bus / PROFIBUS DP
•
– Backplane bus / PROFIBUS DP / PROFINET bus connection was interrupted (wire break on the
bus; bus connector on the communications module was briefly unplugged)
– Backplane bus / PROFIBUS DP / PROFINET master no longer addressing communications mod-
ule
– Execute "INIT"
– The communications module has detected a frame interruption on the bus. The backplane bus,
PROFIBUS or PROFINET may have been reconfigured (e.g. with HW Config or TIA Portal)
This error is only indicated when "Watchdog" has been enabled in the PROFIBUS configuration.
1)
0xE4FE8D00
Internal communications error of the communications module/reader
•
– Connector contact problem on the communications module / reader
– Hardware of the communications module / reader has a defect; → Send in communications module
/ reader for repair
– Start "INIT" after correcting the error
Internal monitoring error of the communications module/reader
•
– Program execution error on the communications module / reader
– Turn the power supply of the communications module/reader off and on again
– Start "INIT" after correcting the error
– MOBY U: Watchdog errror on the reader
0xE4FE8E00 Active command canceled by "WRITE-CONFIG" ("INIT" or "SRESET") or bus connector unplugged
Communication with the transponder was aborted by "INIT"
•
This error can only be reported if there is an "INIT" or "SRESET"
•
0xE5FE0100 Incorrect sequence number order (SN) on the reader/communications module
0xE5FE0200 Incorrect sequence number order (SN) in the Ident profile
Possible cause: User mode "Ident profile/RFID standard profile" is not set in the device configuration.
0xE5FE0400 Invalid data block number (DBN) on the reader/communications module
0xE5FE0500 Invalid data block number (DBN) in the Ident profile
0xE5FE0600 Invalid data block length (DBL) on the reader/communications module
0xE5FE0700 Invalid data block length (DBL) in the Ident profile
126
/ PROFINET error occurred
1)
Ident profile and Ident blocks, standard function for Ident systems
Function Manual, 10/2018, C79000-G8976-C387-04