Figure 2-3 Connecting The Dlc Using Twisted 2-Pair Cable; Cabling - NEC Univerge SV9100 System Hardware Manual

Issue 2.0
S 6 S
ECTION YSTEM
6.1
SV9100 System Hardware Manual
R
EQUIREMENTS AND

Cabling

This section provides cabling requirements and specifications for various
equipment used in the SV9100 system.

Figure 2-3 Connecting the DLC Using Twisted 2-Pair Cable

chassis connected with each of the multiline terminals and single line telephones
by a separate twisted 1-pair cable or 2-pair cable (only for multiline terminals).
Figure 2-3 Connecting the DLC Using Twisted 2-Pair Cable
DLC
Refer to the following tables for cabling requirements and specifications.
Table 2-15 DT400/DT300 Series Loop Resistance and Cable Length on

page 2-27
Table 2-16 DT800/DT700 Series Loop Resistance and Cable Length on

page 2-28
Table 2-17 Cable Connection Between Analog Port and Single Line

Equipment on page 2-28
Table 2-18 Cabling Requirements on page 2-29

Table 2-16 DT400/DT300 Series Loop Resistance and Cable Length
Terminal or Adapter
DTZ-2E-3 ( ) TEL
DTL-2E-1 ( ) TEL
DTZ-6DE-3 ( ) TEL
DTL-6DE-1 ( ) TEL
DTZ-8LD-3 ( ) TEL
DTL-8LD-1 ( ) TEL
DTL-12BT-1 ( ) TEL
DTL-12PA-1 ( ) TEL
DTZ-12D-3 ( ) TEL
DTL-12D-1 ( ) TEL
S
PECIFICATIONS
Twisted 2-Pair Cable
By Twisted 1-Pair Cable
(without AC Adapter)
24 AWG
1,969 ft (600m)
1,969 ft (600m)
1,969 ft (600m)
1,969 ft (600m)
1,969 ft (600m)
1,969 ft (600m)
is a diagram of the
RJ-11
Multiline Terminal
2-31